RouterOS configuration

MikroTik RoMON: Manage Routers Without IP Access

Use RoMON to reach every MikroTik router in your network from one WinBox session, even routers with no IP route to you, and secure it with a secret and forbidden WAN ports.

Commands in this article follow RouterOS v7 documentation but have not yet been marked as lab-tested on this site. Always test changes in a lab or maintenance window and keep a backup.

Problem

You manage many MikroTik routers (for example in an ISP or a campus) and some of them have no IP address you can reach, or their configuration is broken. You still need to log in to them.

Symptoms

  • A router is up but has no reachable IP address.
  • You have to travel to a site just to fix a small mistake.

Likely causes

WinBox normally needs IP or same-segment MAC access. RoMON (Router Management Overlay Network) builds its own discovery and forwarding network between MikroTik routers, so you can hop through one router to reach the others, even across several links.

Prerequisites

  • RouterOS v6.28 or later on all routers.
  • One router you can reach by IP (the "agent").
  • A RoMON secret shared by all your routers.

Solution (WinBox / CLI)

1. Enable RoMON on every router with the same secret:

RouterOS CLI
/tool romon set enabled=yes secrets=Your-RoMON-Secret

2. Do not run RoMON towards the ISP or customers:

RouterOS CLI
/tool romon port add interface=ether1 forbid=yes

3. Connect from WinBox:

  1. Connect to the agent router as usual, then tick Connect To RoMON.
  2. WinBox shows the RoMON Neighbors list with every router the agent can see.
  3. Pick a router and log in with its own username and password.

From the CLI of the agent you can list RoMON neighbors:

RouterOS CLI
/tool romon discover

Verification

The RoMON Neighbors list in WinBox shows all routers with their RoMON IDs (MAC addresses), cost and hop count.

Common errors

  • Different secrets on different routers: they cannot see each other.
  • RoMON allowed on customer-facing ports: customers with MikroTik routers may join your management network. Forbid those ports or use a secret.
  • A Layer 2 device that drops unknown Ethernet frames between routers: RoMON neighbors are missing behind it.

Rollback

RouterOS CLI
/tool romon set enabled=no

Watch the video: MikroTik RoMON: remote router access made easy

Go deeper in class

This topic is covered hands-on in MTCNA — MikroTik Certified Network Associate.

View MTCNA
WhatsApp